1. Configuration Purpose
This procedure allows you to integrate a DT-R relay with an Akuvox R20 video door phone to open the door from the relay by means of an HTTP request. The command is sent to the R20 web interface using the device's IP address and the credentials of an authorized user.
Prerequisite: both devices must have IP connectivity with each other, and the user configured on the Akuvox R20 must have permission to operate the corresponding relay.
2. Akuvox R20 Configuration
2.1 Enable opening via HTTP
Access the Akuvox R20 web interface and open the Intercom > Relay section. In the “Open Relay Via HTTP” section, configure the following:
• Enable the Enabled option.
• Define the username that will authorize the HTTP request.
• Enter the password associated with the user.
• Save the changes by clicking Submit.
Figure 1. Relay parameters and enabling opening via HTTP on the Akuvox R20.
2.2 Disable High Security Mode
Under Security > Basic, locate the “High Security Mode” block and leave the Enabled option unchecked. This change allows the R20 to process the HTTP action used by the DT-R relay.
Figure 2. Disabling High Security Mode on the Akuvox R20.
Security consideration: the request uses HTTP and may include credentials in the URL. It is recommended to restrict access to a controlled local network, use a dedicated security VLAN, and avoid directly exposing the device to the Internet.
3. DT-R Relay Configuration
The first step is to disable the Input Contorl Relay option, since this option is used so that each module input activates its output: input 1 activates output 1, input 2 activates output 2, and so on.
Next, access the DT-R relay web interface and open the Input Link URL menu. For the input that will be used to open the door, configure the following parameters:
Parameter: Recommended configuration
Input Control: Select Yes to enable URL execution.
Server HTTP : Enter the IP address of the Akuvox R20.
User / Password: Enter the credentials previously configured on the R20.
ON URL: Enter the HTTP opening path indicated below.
Method: Select GET, unless the firmware version being used specifies another method.
Opening URL:
http://IP_EQUIPO/fcgi/do?action=OpenDoor&UserName=USUARIO&Password=CONTRASEÑA&DoorNum=NUMERO_RELE
Figure 3. Example of input URL configuration on the DT-R relay.
4. Replacing Variables in the URL
IP_EQUIPO: IP address of the Akuvox R20. Example: 192.168.1.120
USUARIO: Username defined for HTTP opening.
CONTRASEÑA : Password of the configured user.
NUMERO_RELE: Number of the relay that must be activated, normally 1 or 2 depending on the installation.
5. Verification and Troubleshooting
1. Save the configuration on both devices and verify that no errors appear.
2. Activate the associated DT-R input and confirm that the Akuvox R20 relay switches.
3. If the door does not open, verify with ping that communication exists between both devices.
4. Check the IP address, username, password, and relay number included in the URL.
5. Verify that Open Relay Via HTTP remains enabled and that High Security Mode is disabled.
6. If the R20 records the request but does not open the door, check the physical and logical assignment of the door relay.
7. If it does not work, enter the opening URL in a browser and wait for the result. If this appears, the URL is configured correctly.