The ADAM relay module is compatible with the SF-NVR8xxx-4K, excluding the -FACE and -AI
It is very important to check the NVR firmware, it must be version 4.50 or higher
IP CONFIGURATION ADAM MODULE
It is only necessary to set the IP for the ADAM module, for this purpose use the ADAM Net Utility software
The device is detected, the factory IP is set to 10.0.0.1 and the password "00000000", it is added to the software and when selecting it, it will ask for the password:
In the Network section the appropriate IP is set and the changes are applied, with this the module would be ready to be added to the Safire NVR
ADDING THE MODULE TO THE SAFIRE NVR
Remember that it must have a version 4.50 or higher
In the Alarm Extension section the IP of the module will be added, the maximum number of inputs and outputs in the NVR can be 6 (even if the module has more). A maximum of 5 ADAMs can be added
Once added, the inputs and outputs of the module are already available in the recorder and can be used as any relay of the NVR itself: