To use the https://www.autonat.com/ page to access the Safire Smart Recorders and to be able to display and configure them through virtual access to their web server, you must take into account that you need to install 2 plugins:
- The first time you access a Safire Smart device with your PC via the site, you will be prompted to download a plugin after entering the device data, the NS, the user and the password:
Once you have downloaded it, it is VERY IMPORTANT to close all browsers and install the plugin with the browsers closed
- If you then go back to autonat.com and access the recorder again, you will be prompted to download a new plugin. This plugin is different from the previous one, but its installation is the same, close the browser and then install it:
IMPORTANT: You can use any browser if the plugins are installed correctly, Chrome, Edge, etc.
Authorization code:
Starting with Firmware Version 1.4.9, when devices are added to a P2P account using the Security Code method, connecting to the devices via Autonat requires an authorization code.
This feature serves as an additional security measure and is automatically enabled by default for the administrator user. However, this feature can be enabled and disabled in the following section of the recorder. It is important to note, however, that it only supports one user, who, for security reasons, should be the administrator.
Related FAQ´s
- Safire Smart - Adding NVR on Mobile with Safire Smart App
- Safire Smart - Adding NVR on Mobile with Safire Smart Max App
- Safire Smart - Sharing Safire Smart recorder with another account by P2P