The SF-VI104E-IP can operate with or without a display and for this purpose, the two modes of operation will be shown below.
1 - Standalone Mode
2 - Display Operation
The "Quick Press for calling Center" option must be disabled.
Once configured, we check its IP address.
REMOTE DISPLAY SETTINGS
In the remote settings of the display, the IP of our SF-VI104E-IP board must be entered
Note: The SF-VI104E-IP device should not be added in the SAFIRE CONTROL CENTER software, because if it is connected, the call will be sent to the display and at the same time to the software and after the first ringing tone, the call will be terminated on the display and will be routed to the software, therefore, the IP address of the board cannot be in the software.