With a Uniview camera with relay output simulating a Touch Exit to the Safire 2nd Generation video door entry system.
A zone is drawn in motion detection and if the camera detects movement the camera will send a signal to the video door entry system and open the door.
The camera output relay must be set to NO.
Now it is a matter of making the right connections in the SF-VIMOD-CAM-IPboard
Its connections are:
NC1
NO1 Negative wire of the 1st Led simulating a door
COM Red wire bridged with GND and blue wire the com of the Touch Exit button
Door = NC2
NO2 Negative red wire of the 2nd LED simulating another door
GND Black wire from the GND of the Touch Exit Button
12VDC Red wire from the positive of the push button and the positives of the Leds
GND Red wire bridged with COM and the GND of the camera with relay output
AIN2
AIN1
Alarm=AIN3
AIN4 Green wire NO from the push button and the red wire from the camera with relay output
This installation is made in such a way that I can open door 2 (LED2) with the push button and with the camera when it detects movement in the area I have drawn. Door 1 (LED1) will be opened with the Sub module SF-VIMOD-CARD-MF.
We can use AIN3 or AIN4 to simulate doors
The same example with a camera with relay output and a door without leds.