This method only serves to connect the device to the controller and read only the card's credential, since with the fingerprint it will not work and neither with the password.
Steps to follow:
1- Connect the terminal by wiegand to the controller
2- Configure the terminal as follows:
"Direction: Send"
"Mode: Wiegand26"
(The picture shown is an invalid example and must be left configured as specified above)
(Menu - Communication - Wiegand)
3- It is important that the users are also created on this computer so you will also need to have the computer connected by network as well as the controller
4- Finally we will see how the device sends us the credentials of the card to the controller.
