📹 Step 10: Set up smart features
For cameras with smart features, you can activate the following options:
- Motion detection
- Line crossing
- Area Intrusion
- Regional Entry
- Regional Leave
- For the PTZ camera: set patrols or preset positions
📹 Motion detection
Setup:
- Go to the Camera menu and select Motion, then select the desired camera.
- Motion detection is enabled by default. If this is not the case, enable it.
- All detection area is entire image
- Reverse drawn area
- Clear drawn area
- Set the alarm schedule: determine when the function should be active by going to Processing Mode.
- Under the Trigger Actions tab, you can set what happens when detection occurs (e.g., push notification, recording of a channel).
📹 Line Crossing and Intrusion
These functions can be found under AI / Event on the recorder. Available options depend on the camera model.
Setting line crossing:
- Select Perimeter Detection
- Select the camera
- Select AI Event Line Crossing
- Enable Detection by NVR or IPC
- Parameter Settings
- Area
- Schedule
- Direction
- Detection Target
- Trigger Mode
- Trigger General
- Record
- Alarm-Out of NVR or added cameras
- Trigger Preset for PTZ or cameras with zoom
- Trigger IP Speaker
The same steps apply to all the other AI Events
🧠PTZ camera: Cruises and Preset positions
- Go to Live View and select the PTZ camera.
- Open the PTZ menu on the right side.
- Use navigation and zoom to determine the desired position.
- Add a preset, give it a name, and save it.
- Repeat this for other positions.
🧪 Stap 11: Testing and validation
- Check live images on the NVR and via the app.
- Test notifications and recordings when motion is detected.
- Check whether audio is working (if applicable).