For this, you need to have two RG-EST310-V2 kits, a router and a PC or laptop.
First, you take one kit and follow the configuration process.
Second, you back up the configuration file from the RG-EST310-V2 camera end of the first kit and upload it to the camera and recorder end of the second kit.
________________________________________________________________________________________________________________
When you have the RG-EST310-V2 recorder end connected to the router (switch) you do not need to connect the RG-EST310-V2 camera end to the router, just make sure it is within 60° of each other.
Find the IP address of the RG-EST310-V2 recorder end, as it must be connected to the main network.
Enter the IP address of the RG-EST310-V2 recorder end in Internet Explorer.
1. At the top of the Recorder End configuration page, you see the errors and tasks to troubleshoot and configure.
2. Set the hostname.
Move the mouse over the number to take the action, and in this case, this is 2 (for the two actions to take).
3. In the new pop-up window, click on the pencil to change the name and double check with the MAC address to make sure you edit the correct one. This is needed when you have more than one configured on your network.
3. Set the password.
4. Set the WDS password.
5. Then change the country and region.
Note: Make sure that all devices that are on the same network have the same time zone and country.
6. When the devices do not reboot, reboot both devices.
Now, for the following devices on the RG-EST310-V2 camera end, we have to follow the next steps.
Clones the RG-EST310-V2 camera end devices.
When adding more camera receivers, the best practice will be to back up the existing RG-EST310-V2 Camera End. To do this, it is also possible to use an RG-EST310-V2 Recorder End to convert it into an RG-EST310-V2 Camera End device.
Now enter the IP address of the RG-EST310-V2 Camera End device in Internet Explorer.
1. Log in and go to System Tools > Management > System Tools > Management.
2. Make sure that you are on the Backup and Import tab.
3. Click the Backup button to make a backup (tip: check that the LAN settings are set to DHCP after cloning so that you can use a fixed IP address when necessary).
4. Connect the next end of the RG-EST310-V2 camera from the recorder end to the same network with the cable.
5. Enter the IP address in Internet Explorer and go to System Tools > Backup & Import tab.
6. Import the backup file you just created.
After this, the device will reboot.
Once all the steps have been completed, it should look similar to the image below.