Once the camera is turned on, it can be detected with the IP Manager Tool software to activate it and set an IP address:
Once this is done, the camera can be accessed with the browser and configured.
Configuring the APN for communication via the SIM card
In the Network section you can access all network parameters, where one of the most interesting for this camera is the APN configuration:
Dialing State - Information on the status of the data connection
Dialing Parameters - SIM card data settings (APN, username and password)
Power Consumption Modes
- Full Power Mode
In this mode the camera remains active.
- Low Power Mode
This mode keeps the 4G network, PIR (passive infrared) detection and event recording active. The camera goes to sleep when it does not detect motion, which helps to conserve power
Note: In low power mode, parameters such as the frequency of the audible alarm and the frequency of the flashing alarm may change.
- Manual Sleep
In Manual Sleep, you can set a schedule for when the camera should go to sleep mode.
Alarm
Motion Detection Configures the motion detection area, sensitivity, activation mode and schedule Exception Alarm Configure the relevant parameters of the abnormal alarm, as well as the linkage after several abnormal alarms. Alarm Server Configuration and settings of the alarm server Audio Alarm Configure the relevant information about the audio alarm. Light Alarm Configure the relevant information about the light alarm. PIR Alarm Configure the PIR information. Event
Object Abandoned/Missing Intelligent detection of abandoned or missing items. Video Exception Image distortion correction. Line Crossing Intelligent analysis of line crossings Region Intrusion Intelligent Region Intrusion Detection
Scheduled screenshots
The Time lapse function, which saves screenshots every X seconds, is performed as follows:
1. Snapshot Parameters
2. Event Trigger
3. Timing Snapshot